Introduction

Provide Water for Chickens: The glass has a yellow trigger that will attract chickens to peck it, When chickens peck the yellow trigger, the chicken waterer valve automatically releases water into the plastic cup. Provides clean water to chickens, and doesn't waste water.

Easy To Install:It is so easy and quick to setup this chicken waterer as all you need to do is drill a hole on your container and screw in the Waterer nut Kit. The only thing you'll need for installing the watering nipples is an 9mm drill bit. The nipple nut screws right into your container, so additional tools will NOT be necessary.

Easy To Clean: There is a soft plastic leak-proof design at the connection with the bucket and it will not leak.These poultry waterer can be easily installed in the side or bottom of a bucket(can use a 9mm(3/8'') drill bit to create holes, 1" above the base of the bucket ), or connected to the water pipe. The red cup and yellow rod is removable, so it is easy to clean.

Note: Please check the feeder once a week to see if there are insects or fungi, and wash it regularly with mild soap and water solution.

Question:You will receive 10-pcs Chicken Drinking Cup. If you have any question about this item,please feel free to email to us.We are always here to help.

CONTAINER INSTALLATION INSTRUCTIONS

Step 1. Using a 9mm drill bit, drill a hole in the side of the container for each cup.
Step 2. Remove any burrs or debris from around each drill hole.
Step 3. Remove wingnut and insert cup assembly into the hole until the rubber washer contacts the outside of the container.
Step 4. Hold the cup in place ensure the correct position while screwing the wingnut onto the thread inside the bucket and tighten by hand.
Step 5. Thoroughly wash out the container after installation, to ensure that it is free of all residual debris. Dirt and plastic shavings may cause water cups to stop functioning correctly.
Step 6. Find a location to place or hang the container so the cups are at a suitable height for your birds.